High and New Industrial Zone, Kexue Revenue, Zhengzhou, China

News
  1. Home
  2. Drying Machine
  3. Workability Of Quarry Dust In Concrete By Slump Cone
Workability Of Quarry Dust In Concrete By Slump Cone

Workability Of Quarry Dust In Concrete By Slump Cone

  • Utilization of Stone Dust as Fine Aggregate

    Utilization of Stone Dust as Fine Aggregate

    The workability of fresh concrete was measured by the slump test. The slump test indicates the behavior of a compacted concrete cone under the action of gravitational forces. The slump values for different percentage of stone dust in concrete as shown in table 3. It

  • Partial Use of stone dust in concrete as an alternative of

    Partial Use of stone dust in concrete as an alternative of

    The degree of workability required depends on three factors. These are the size of the section to be concreted, the amount of reinforcement, and the method of compaction to be used. There are three ways to measure the workability of a fresh concrete i. Slump Cone Test ii. Compaction Factor Test iii.

  • International Journal of ChemTech Research

    International Journal of ChemTech Research

    3.1.1 Slump Test The slump cone test determines the workability of a freshly mixed concrete compiling to the standards of IS 1199- 195912, which measures the consistency of concrete in a particular and specific batch. The slump test is the most well-known and widely used test to characterize the workability of fresh concrete. Table 7. Slump ...

  • An Innovative Method of Replacing River Sand by

    An Innovative Method of Replacing River Sand by

    Quarry Dust Waste in Concrete for Sustainability. ... Slump cone tests were done to. determine the co. n-si. s. tency and workability of . control and test specimens, and there . was enough . workability . and consistency . for both the control spec. i-mens, as well as the test specimens which us. ed .

  • Investigation on mechanical properties of composite

    Investigation on mechanical properties of composite

    Jan 01, 2020 Six concrete mixes M1 to M6 were casted using river sand M1-control mix and blending untreated sea sand and quarry dust in varying percentages from 0 to 100 at a step interval of 25. Workability parameters, slump height and vee-bee time were determined to assess the consistency of mixes.

  • Consistency and mechanical properties of sustainable

    Consistency and mechanical properties of sustainable

    Mar 04, 2021 Variations in slump value of the concrete mix are as a result of the physical properties of BDW influencing the consistency of fresh concrete with varying brick dust content . In a similar study where BDW was added to a concrete mix at 10, 20 and 30, similar trend of

  • EXPERIMENTAL INVESTIGATION ON UTILIZATION OF

    EXPERIMENTAL INVESTIGATION ON UTILIZATION OF

    5.1 Slump Cone Test Slump Cone test was performed for the samples to know the workability of the concrete.The results shows that initially slump started increasing with the addtion of plastic upto 5 and futher addtion of the plastic results in the decrease in the slump. Chart-1 Slump Cone Test values

  • Comparative Analysis of Engineering Properties of Indus

    Comparative Analysis of Engineering Properties of Indus

    Mar 15, 2021 Slump The quarry dust concrete and river sand concrete shoed slump test values of 80 mm and 60 mm, respectively. And, fresh concrete mix of quarry dust concrete showed lower workability than river sand concrete for 124 mix ratio and water-cement ratio of 0.55. The higher slump interposed for quarry dust may be due to higher

  • Strength and Durability Properties of Concrete

    Strength and Durability Properties of Concrete

    percentage-mixes of quarry rock dust with natural river sand. It is observed that the slump value increases with increase in percentage replacement of sand with quarry dust for the same water-cement ratio. Table 5 Showing the workability of each specimen at constant water-cement ratio Mix of Quarry Dust Mixing Ratio Mass of Water

  • Sagar Panchal1 Molly Mathew2

    Sagar Panchal1 Molly Mathew2

    workability of concrete depends on the water cement ratio and the water absorption capacity of ... In this case slump cone test was done for measuring the workability of concrete as shown in Figure 1. In this water ... The measured values of quarry dust concrete with constant water cement ratio at 0.44 are found to be 80, 75, 70, 65, 60, 60 mm ...

  • Workability Strength and Durability Properties of

    Workability Strength and Durability Properties of

    Apr 22, 2021 Saeed Ahmad et al. 200811 found that concrete compressive strength increased and workability decreased with increasing proportion of M-Sand. Balamurugan et.al.20138 ascertained that quarry dust can be utilized in concrete mixtures as a good substitute for river sand with higher strength at 50 replacement.

  • Partial Replacement of Fine Aggregates with Quarry

    Partial Replacement of Fine Aggregates with Quarry

    1.2 Properties of Quarry dust Table 1.2 Properties of Quarry dust Organic material content Nil Compatibility with cement Use any type of Portland cement and blended cements for various mix designs Setting time Normal as preformed by river sand Workability Good Yield Rich mix Standard mix design for M20 grade concrete per Cum.

  • Use of Quarry Dust to Replace Sand in Concrete An

    Use of Quarry Dust to Replace Sand in Concrete An

    To determine consistency of concrete, Slump test was conducted with varying water content and a particular water cement ratio wc which gives the slump of 60mm was selected from graph. The various wc for different proportions of sand and quarry dust was presented in Table 2. Table 2 Workability of concrete slump 60mm

  • Improved Concrete Properties Using Quarry Dust as

    Improved Concrete Properties Using Quarry Dust as

    Apr 08, 2015 Improved Concrete Properties Using Quarry Dust as Replacement for Natural Sand 51 3. BULKING OF AGGREGATES The bulking properties of quarry dust are examined as specified as specified in IS 1180. Fig.9 Shows the results of bulking of quarry dust 4. WORKABILITY The slump value had been measured during the casting of specimen.

  • Quarry dust concrete

    Quarry dust concrete

    Quarry dust concrete Products. As a leading global manufacturer of crushing, grinding and mining equipments, we offer advanced, reasonable solutions for any size-reduction requirements including, Quarry dust concrete, quarry, aggregate, and different kinds of minerals.

  • QUARRY DUST FINE POWDER AS SUBSTITUTE FOR

    QUARRY DUST FINE POWDER AS SUBSTITUTE FOR

    In order to determine the workability of the fresh concrete, slump test was conducted in accordance with BS EN 12350-22000 9. The slump test is conducted to ensure that the designated concrete mixes satisfy the requirement of the workability, i.e., slump of 40 mm to 50 mm and 100 mm to 150 mm for mixes without and with Sp respectively. 2.3.2.

  • Partial Replacement of Sand by Quarry Dust in Concrete

    Partial Replacement of Sand by Quarry Dust in Concrete

    quarry waste and its effect on the strength and workability of concrete. This paper reports the experimental study which investigated the partial replacement of sand with quarry dust. Initially cement concrete cube was studied with various proportions of cement concrete quarry dust

  • Quarry Mud as Partial Replacement for Fine Combination

    Quarry Mud as Partial Replacement for Fine Combination

    6.4. Workability of Quarry Dust Material. Procedure The workability is one of the physical parameter of concrete which affect the strength and durability and the appearance of the finished surface. If the water absorption capacity if the aggregates. In our case we have used slump cone test for measuring the workability of concrete.

  • A Study on Mechanical Properties of Concrete Incorporating

    A Study on Mechanical Properties of Concrete Incorporating

    In addition, the MIX7 mixture, which incorporated 10 of Al dross, 15 of fly ash, and 20 of quarry dust, also achieved a high slump value for concrete with good workability. However, with the increase in the percentages of Al dross as in the mixtures of MIX4 and MIX5, the workability decreased.

  • COMPRESSIVE STRENGTH AND WORKABILITY OF

    COMPRESSIVE STRENGTH AND WORKABILITY OF

    the range for normal weight concrete and although laterized quarry dust concrete had poorer workability, their compressive strength compare favourably with those of conventional concrete. The use of laterized quarry sand concrete for structural members is therefore recommended when laterite content is not more than 50.

  • Research Paper RELATION BETWEEN WORKABILITY

    Research Paper RELATION BETWEEN WORKABILITY

    investigated the use of quarry dust in self-compacting concrete. Moreover, the influence of limestone powder on self - compacting concrete is ... Workability of fresh concrete There is no acceptable test, which can directly ... a normal slump cone and a steel plate